Maven MD-FILM 600

MD-FILM 600 is the single-side coated PET transfer film used in DTF systems. It ships 60 cm wide, in 100 metre rolls, at 75 micron. There are two variants: MD-FILM 600-C cold peel and MD-FILM 600-H hot peel. Only one face is coated — printed on the reverse, the job holds no powder and will not transfer. The anti-static back face reduces blocking and dust pickup on the roll. When the film changes, ink absorption changes with it and the profile has to be rebuilt.

• PeelSet Two Variants — 600-H hot peel comes off the moment the press opens and lifts shift throughput noticeably; 600-C cold peel waits until the film is below 40 °C but holds fine type and sharp edges more reliably. The two coatings differ and cannot be mixed within a job.
• InkHold Single-Side Coating — ink only anchors on the coated face. A water drop identifies it: the drop beads on the coated side and spreads on the reverse. Printed on the wrong face the job carries no powder and you only find out at the oven — the classic first-day mistake.
• FlatFeed Curl Resistance — the 75 micron PET carrier holds its dimension at oven temperature and does not ripple on the take-up shaft. Film stretches as it heats, and the thinner the carrier, the more that stretch turns into misregistration between colour and white.
• AntiStatic Back Face — the reverse is treated against static build-up. In a dry shop, statically charged film both attracts dust and blocks against itself on the roll; either one shows up as speckling in the transfer.
• MavenMatch Profile Pack — ICC profiles and ink limits are ready for the MD-600 A4 + MI-710 DTF + MD-PWD 170 combination. Move to another film and the profile must be rebuilt — that is a requirement, not a preference.